3.1001.5 Penetrations and Chases

Topic: 
Attics
Subtopic: 
Penetrations and Chases
Desired Outcome: 
Penetrations and chases sealed to prevent air leakage and moisture movement between the attic and conditioned space
For supporting material, see Referenced Standards.
TitleSpecification(s)Objective(s)
3.1001.5a
Pre-inspection

Gaps, cracks, and holes in fire separations located within the work area will be visually identified and incorporated into air sealing work scope, including those that span two conditioned or unconditioned spaces

Where drawings are available that identify specific fire-resistance ratings (i.e., 1 hour, 2 hour), materials and methods will be employed to preserve or restore such rating

Where drawings are unavailable or do not identify specific fire-resistance ratings, the fire-resistance rating of the assembly may be inferred from the current construction (i.e., single 5/8 sheetrock, concrete masonry unity), and materials and methods employed will be consistent with restoring or preserving such inferred fire-resistance rating

Ensure a continuous air and fire barrier will be appropriately located between conditioned and unconditioned space

3.1001.5b
Backing and infill

Where gaps, cracks, or holes are larger than 1/4" across and/or where the air sealing materials will be subject to temperature variations in excess of 50° F, the need for backing or infill will be evaluated

If used, backing or infill will meet specific characteristics of the fire-resistance-rated assembly, and be compatible with the characteristics of the gap, crack, or hole, including preservation of any expansion/contraction characteristics for assembly (e.g., expansion joints, steam pipes, or dissimilar material interfaces with differing coefficients of expansion)

Backing or infill will be selected that maintains sealant placement and durability while allowing for the expected movement from expansion, contraction, load deflection, settling at the location, or if existing water control measures are compromised (e.g., rain screen, drip edge, weep holes, gutter and roof drains, scuppers, or other exterior water management elements)

Minimize gap or hole size to ensure successful use of sealant

Ensure closure is permanent and supports appropriate load (e.g., wind, snow, insulation)

Ensure sealant does not fall out

Ensure integrity of the existing water control system

3.1001.5c
Sealant selection

Sealants will be compatible with their intended surfaces and applied in accordance with manufacturer specifications

Selection will be durable, pest resistant, and have a weather-appropriate seal

Indoor sealants will be low volatile organic compound ( VOC VOC Volatile organic compound ) products that meet independent testing and verification protocols, such as Green Seal GS-36, "GREENGUARD Children and Schools," or comparable certifications

Fire-resistance-rated assemblies will be provided with sealants permitted by the authority having jurisdiction and adopted building code

Prevent intrusion of moisture and pests into the sealed assembly

Prevent exposing workers or occupants to excessive VOC VOC Volatile organic compound levels

Ensure sealant meets or exceeds the performance characteristics of the assembly and is compliant with local fire code requirements

3.1001.5d
High temperature application

Only noncombustible sealant will be used in contact with chimneys, vents and flues, or any heat source (e.g., non- IC IC Insulation contact -rated recessed lights, heat lamps, etc.)

Sealant application at factory-built vents, flues, and chimneys shall be listed for use with that vent assembly

Preserve integrity and any applicable warranty associated with factory built vent, flue, or chimney assemblies