Security Lighting

Select security light fixtures that:

are UL approved for location installed (i.e., indoor, outdoor, wet location)

provide the required lighting conditions with the lowest possible energy-use

are vandal-proof

are dark sky approved

are ENERGY STAR^® qualified, equivalent, or better

De-energize circuit and lock out power before work begins

Install lighting in accordance with manufacturer specifications and applicable code (e.g., NFPA 70)

Aim light fixtures to minimize light emitted above the horizontal, beyond the perimeter of the property, and not directly into any window of a residence

Clean the lens and reflector once installation is complete

Install both photo and motion sensors and configure to only activate when sun is down and to switch off within 5 minutes if no motion is detected

Permanently remove equipment from job site and recycle or dispose of removed equipment and refrigerant in accordance with local and federal law (e.g., EPA Section 608 of Clean Air Act of 1990)

Permanently decommission old equipment

Provide occupants/owners with user's manual, warranty information, installation instructions, and installer contact information